£225.00
We designed these free swinging plates to use on our Air Suspension Kits Rear End. It is designed to be used without a torsion bar and pivots freely on a quality hemispherical bearing (Rose Joint). It would also work well with a coil over shock system. Easy to install.
Shock usually needs be released at lower mount to get wheel off depending on how low you go.
| Weight | 4 kg |
|---|---|
| Dimensions | 50 x 25 x 20 cm |
If your bus was built between ‘70 and ‘72 (disc brake models) you must check your current spring plates before ordering adjustable ones. (see instructions on page 19 of our online catalogue) During this period the diameter and number of … Continued
This is the Spring Plates you will need if you have a standard Splitscreen Rear Suspension with Reduction boxes but wish to have height adjustability. This can be helpful if your bus has settled with one side lower than the other and … Continued
These Spring Plates are required if you are using a Type 3 Swing axle conversion. Be aware that excessive negative camber will occur if you plan to lower the bus more than 3-4″ This will result in severe tire wear. Easy to … Continued
Standard with our IRS Kit for lowered splits This is the Spring Plate we offer as standard on our IRS kit. It will allow drops from 3″ downwards and will give the lowest drop we can deliver. Use on our … Continued